8 thoughts on “ Something - Orifice (2) - Gollywoggle (CD) ”

1. Mazuzshura 10.08.2019 at 15:47

   2 pressure differential. The wedge flow meter has a wedge shaped obstruction located in the upper portion of the pipe, which reduces pressure on the downstream side of the wedge. Fig. 1 shows sketches of the different types of meters investigated. The viscosity of a fluid is inversely proportional to the Reynolds number for aMissing: Something.

   Reply ↓
2. Arabar 10.08.2019 at 16:24

   a =area of orifice, ft 2 (m 2) g =acceleration due to gravity, ft/s 2 (m/s 2) h =head on horizontal center line of orifice, ft (m) Advertisements. The coefficient of discharge C is the product of the coef- ficient of velocity C v and the coefficient of contraction C c. The coefficient of velocity is the ratio obtained by dividing the actual.

   Reply ↓
3. Kajizshura 05.08.2019 at 17:29

   Consider a small orifice in the side of a vessel with the head of water above the orifice kept constant. Figure 2: Discharge through an orifice Applying Bernoulli's theorem between the surface of the water 1 and the orifice O yields Typical values of Cd range from 0·6 to 0·65, i.e. the actual flow through a sharp edged orifice is.

   Reply ↓
4. Jusho 03.08.2019 at 13:44

   I'm trying to find the discharge coefficient (Cd) for an orifice knowing the orifice diameter, the inner diameter of the tubing, and the flow coefficient provided by the manufacturer. I've tried.

   Reply ↓
5. Malacage 09.08.2019 at 14:55

   Orifice plate material. 2. Identify and accumulate data on process flow conditions. a. Fluid to be measured. b. Pressure. c. Temperature. d. Viscosity. e. Flow rates (Minimum, Normal and Maximum) 3. Identify and accumulate information on other requirements of the flow meter. a. Missing: Something.

   Reply ↓
6. Grozahn 06.08.2019 at 15:46

   Connect these orifices to threaded pipe, or insert them into threaded holes. Also known as flow restrictors and precision orifice valves, they are used to throttle, vent, bleed, or regulate the flow of liquids and gases.. Stainless steel orifices are more corrosion resistant than brass orifices.. stainless steel orifices have better corrosion resistance than stainless steel orifices.

   Reply ↓
7. Jugul 11.08.2019 at 16:34

   3) Coefficient of Discharge (Uncertianity) The estimated uncertainty of the empirical coefficient of discharge for concentric, square-edged, flange-tapped orifice meters that are in compliance with this standard (API ) is a function of the Reynolds number and the diameter ratio (β). i.e: Cd (Uncertainty) is a function of Reynolds Number & Diameter ratio.

   Reply ↓
8. Zologore 09.08.2019 at 19:10

   I'm trying to find the discharge coefficient (Cd) for an orifice knowing the orifice diameter, the inner diameter of the tubing, and the flow coefficient provided by the manufacturer.

   Reply ↓